The Reel Lawn Mower – An Introduction

June 2nd, 2010 Posted in Tools and Equipment

Lawn mowers are broken down into 2 basic categories- reel mowers and rotary mowers. The 1st reel lawn mower was invented by a British engineer by the name of Edwin Budding in 1830. The rotary lawn mower was invented in 1933 by a company called Power Specialties of England. In order to figure out which sort of mower is most suitable for you, it’s vital to take a look at what both have to offer . Read on

The Reel Lawn Mower

Reel lawn mowers are made from blades that turn around on a cylinder. As the name suggests, the blades are called a reel. It’s the reel that cuts the grass, graszoden in Dutch. Some reel mowers have to be by hand pushed by an individual to work while others have an engine.

The reel mower has revolving blades that connect to a stationary bar that lies parallel to the ground below. As the mower is pushed forward, the blades and the bar ( known as a bed knife ) make contact with one another. It’s the bed knife that makes the grass stand upright so that it can be cut by the blades. The reel mower is often known as having a shearing action and can be changed to chop grass that is of varying heights.

It is thanks to the shearing action that reel mowers can cut to a shorter length than can rotary mowers. The cut is also much cleaner. For example, reel lawn mowers are used on golfing courses versus rotary mowers for this very reason. The grass clippings from a reel mower have a tendency to be finer than most rotary mowers, with the exception of special mulching rotary lawn mowers.

The bed knife of a reel mower must be changed accordingly to cut the grass correctly . The grass won’t be cut very well if the bed knife is either too near to the blades or too far away. Adjusting the bed knife is commonly a{ very |n extremely | easy task to perform.

The Rotary Lawn Mower

Rotary lawn mowers on the other hand are composed from a flat horizontal blade that turns in accordance with the engine’s speed. The engine of a rotary mower is on a housing called a deck. The shaft of the engine goes through the deck and the blade that cuts the grass is scrupulously attached with a bolt to the bottom of the shaft. It sounds more complicated than it is. The underside of the deck is there to give protection to the individual using it from being wounded by the blade. The bottom is also there to make sure the grass is lifted up as it is meant to be.

Traditional rotary lawn mowers have given way to a selection of rotary mulching lawn mower thatis superb at cutting grass into terribly fine pieces. Some of these mulching lawn mowers are made with a single blade while others have 2 blades. Most of the more recent rotary mowers have 2 blades.

Rotary lawn mowers work fine on grass that is long but don’t tend to cut as cleanly or as uniformly as do their manual opposite numbers, the alreadymentioned reel mowers. The spinning blade of a rotary mower has the disposition to bend the grass as it is going over it which means that some pieces of grass remain standing while the rest is cut.

If you were thinking about to replenish the grass in your garden, then get some ideas from grasmatten.